aim assist flying aol over the place

All about waroverlay
Post Reply
DesertFox327
Posts: 59
Joined: 11 Jan 2018, 21:01
Contact:

aim assist flying aol over the place

Post by DesertFox327 » 12 Jun 2018, 20:46

Hello....since the update my aimassist will not lock on to a target like before...It circles all around , up and down and will not lock on as before..I am using Mouse auto aim...Are my settings off? I finally got them to where they were comfortable...my sensitivity is 110 and my invert is 160...I have asked numerous times what the invert should be set to and what it's function is but I never got an answer so I tried different settings...I finally found one that works now it is a little wonky...I also know that it will probably take a little while to get used to the new version....
User avatar
admin
Site Admin
Posts: 686
Joined: 21 Apr 2016, 21:36
Contact:

Re: aim assist flying aol over the place

Post by admin » 12 Jun 2018, 20:47

Try to lover your inversion value, inversion value defines aiming range on opposite side of targeting aim from maker.
DesertFox327
Posts: 59
Joined: 11 Jan 2018, 21:01
Contact:

Re: aim assist flying aol over the place

Post by DesertFox327 » 12 Jun 2018, 22:41

Thank you I will give that a try...I switched from mouse to angle and it seemed to make a small difference as well...I will report back and let you know..Thank you for being so on top of the update...
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest